Body Solid FLP Assembly Instructions And User's Manual page 12

S T E P
6
Be careful to assemble all components
S T E P
in the sequence they are presented.
6
NOTE:
Be careful to assemble all components
Finger tighten all hardware in this step. Do Not wrench tighten until end of step 6.
in the sequence they are presented.
A. Attach the Stamped Eye End of Cable (D6) to the gym using:
One A12 (M10x20 allen head bolt)
One B1 (M10 nylon lock nut)
B. Route Cable (D6) across (D1-F) and (D1-E). Bring the cable under (D1-A), around (D1-D), (D1-A) and (D1-C).
C. Connect Snap Link (D9) to the Chain Link End of steel Cable (D6).
D. Connect Cable (D6) to Mainframe (A) as shown in Diagram B using:
One A10 (M10x60 hex head bolt)
Two C1 (M10 washer)
One B1 (M10 nylon lock nut)
mm
0 10
0
Inch
20 30 40 50
1" 2"
60 70 80 90
12
3"
16
100 110 120 130
4" 5"
140 150
6"