Body Solid FLP Assembly Instructions And User's Manual page 10

S T E P
5
Be careful to assemble all components
in the sequence they are presented.
S T E P
5
NOTE:
Be careful to assemble all components
Finger tighten all hardware in this step. Do Not wrench tighten until end of step 6.
in the sequence they are presented.
A. Connect Seat Pad (M) to Mainframe (A) by using:
One A11 (M8x80 hex head bolt)
One A7 (M8x100 hex head bolt)
Two C4 (M8 spring lock washer)
Two C3 (M8 washer)
B. Insert End Caps (D2) to ends of Back Pad support (F).
C. Connect Plastic Sleeve (D3) to Mainframe (A) as shown in the diagram. Insert End Cap
into the end of Back Pad Support (F).
D. Slide Back Pad Support (F) through Mainframe (A) as shown in the diagram.
E. Connect Back Pad (N) to Back Pad Support (F) by using:
Two A8 (M8x50 hex head bolt)
Two C4 (M8 spring lock washer)
Two C3 (M8 washer)
F. Slide Pad Wrap onto Back Pad (N).
mm
0 10
0
Inch
20 30 40 50
1" 2"
60 70 80 90
10
3"
100 110 120 130
4" 5"
140 150
6"