Table of Contents
Advertisement
Appendix
Troubleshooting
If you have difficulty with your phone, please try the following suggestions.
For Customer Service, visit our website at
1 (800) 222-3111
call
My telephone doesn't work at all.
•
Make sure the power cord is securely plugged in.
•
Make sure you plug the battery connector securely into the cordless handset.
•
Make sure you plug the telephone line cord securely and firmly into the
telephone base and the telephone wall jack.
•
Charge the battery in the cordless handset for at least 10 hours. For
optimum daily performance, return the cordless handset to the telephone
base or charger when not in use.
•
If the battery is depleted, it might take approximately 30 minutes to
charge the handset before it shows Low battery. See page 8 for details.
•
Reset the telephone base. Unplug the electrical power. Wait for
approximately 15 seconds, then plug it back in. Allow up to one minute for
the cordless handset and telephone base to reset.
•
You may need to purchase a new battery. Please refer to
Battery installation and charging in this user's manual on pages 8-9.
The display shows No line. I cannot get a dial tone.
•
Try all the suggestions, as mentioned above.
•
If the previous suggestions do not work, disconnect the telephone line
cord from your telephone and connect the telephone line cord to
another telephone.
•
If there is no dial tone on that other telephone either, your telephone
line cord may be defective. Install a new telephone line cord.
•
If changing the telephone line cord does not help, the wall jack (or
the wiring to this wall jack) may be defective. Try using a different wall
jack in your home to connect your CL82143 telephone, or contact your
telephone service provider (charges may apply).
www.telephones.att.com
. In Canada, dial
80
1 (866) 288-4268.
or
Advertisement
Table of Contents
