Magic Chef MCSCD6W1 User Manual page 11

C) Water Intake Hose: Connect to the rear of the dishwasher using the large, 4-corner
shaped wing nut.
D) Drain Hose: Connect to the rear of the dishwasher. It is suggested you use pliers
to tighten but DO NOT over tighten.
E) With both hoses connected, make sure you can plug the power cord into a 120
volt, grounded AC outlet, then turn the dishwasher so it is facing forward.
F) Red Pressure Release Button: This red button, located on the Quick Release
Faucet Adapter, is used to release the water line pressure. When you first connect
to the water faucet, you can press the red button to check the water is at the
desired temperature or to use the faucet normally without removing the whole
Quick Connect Adapter.
Red Pressure
Release Button
This part can be unscrewed into two
parts to adjust for different faucet sizes.
G) With all the fittings connected, open the water tap to test to make sure there
are no leaks. Connect the A/C power cord and use the dishwasher as outlined in
the manual.
H) When finished using the dishwasher, you need to close the water supply at the
tap and disconnect the power supply cord.
Release Button on the Quick Connect Adapter, which will depressurize the water in-
take hose to easily remove without squirting water, which can be very hot and cause
scalding or personal injury. The Quick Connect Adapter should then be disconnected
from the faucet and stored for its next use.
of children is always important around the appliance.
The water intake hose is now pressurized. Press the Red Pressure
DO NOT let children disconnect the dishwasher. Close supervision
Water Hose
Drain Hose
Red Pressure
Release Button
This end connects
to the sink faucet.
11