Kia 2011 RIO Owner's Manual page 261

4. Unsnap the headlight bulb retaining
wire by pressing on the lower portion
of the wire, then pushing it towards the
outside of the vehicle. Maintain light
pressure on the wire and allow the
wire to raise upward to its fully
released position.
5. Remove the bulb from the headlight
assembly.
6. Install a new headlight bulb and snap
the headlight bulb retaining wire into
position by aligning the wire with the
groove on the bulb.
7. Connect the headlight bulb socket-
connector.
8. Install the headlight bulb cover by turn-
ing it clockwise.
Front turn signal/position light
bulb replacement
1. Open the hood.
2. Remove the socket from the assembly
by turning the
counterclockwise until the tabs on the
socket align with the slots on the
assembly.
3. Remove the bulb from the socket by
pressing it in and rotating it until the
tabs on the bulb align with the slots in
the socket. Pull the bulb out of the
socket.
4. Insert a new bulb by inserting it into
the socket and rotating it until it locks
into place.
5. Install the socket in the assembly by
aligning the tabs on the socket with the
slots in the assembly. Insert the socket
into the assembly and turn the socket
clockwise.
1JBA7023
Front fog light bulb replacement
If the light bulb is not operating, have the
vehicle checked by an authorized Kia
dealer.
socket
Maintenance
7 41