System Requirements - Sony BWU-100A Operating Instructions Manual

System
Requirements
The drive should be used with a system that
meets the following requirements
❑ PC/AT-compatible computer
❑ One available EIDE (ATAPI) interface
connection with DMA capability
❑ One empty 5-inch half-height drive bay
❑ One available internal +12 V/+5 V
3)
power connector
CD/DVD Burning
❑ CPU: Pentium III 800 MHz or faster
❑ 256 MB RAM or more
❑ 5.0 GB free HDD space or more
❑ Operating system: Windows 2000
Professional, Windows XP SP2 Home
Edition or Professional
BD AV Application
❑ CPU: Pentium 4, 3.0 GHz or faster
❑ 512 MB RAM or more
❑ 30 GB free HDD space or more
❑ Operating system: Windows XP SP2
Home Edition or Professional
❑ IEEE1394 (i.LINK) port (for HDV
camcorder connection)
❑ Recommend UXGA (1600 × 1200)
resolution computer display
❑ Appropriate graphics card supporting
UXGA (1600 × 1200) resolution
computer display
1)
The above requirements are the minimum
necessary requirements to write to disc
normally. Under actual operating conditions,
the requirements imposed by your software
must also be met. For details, refer to your
software documentation.
1)
.
2)
The drive does not support connection to an
ATAPI interface extension card. Connect the
drive to the IDE (ATAPI) interface connector
of your computer's motherboard.
2)
3)
The drive consumes a lot of power when
operating at high speeds. You should therefore
make sure that the rated power output of the
power outlet where you connect all your drives
is sufficient to power all the drives, including
this one. For details about each drive's power
consumption rating, refer to their
documentation.
7