Installation - Electrolux ESF 6700ROW User Manual

12. INSTALLATION

12.1 Fitting under a kitchen
counter
The plinth of a freestanding appliance is
not adjustable.
Do not remove the appliance worktop if
you want to use it as a freestanding unit.
820 mm
Removing the worktop
3
Adjusting the level of the
appliance
A correct adjustment of the level of the
appliance allows the door to close and
seal correctly.
If the door does not close correctly, loos-
en or tighten the adjustable feet to level
the appliance.
min 570 mm
600 mm
1
2
4
It is not necessary to remove the worktop
when installing under a standard kitchen
counter.
Only remove the appliance worktop to in-
stall it under a close fitting sink unit or
kitchen counter (820 mm).
1. Put the appliance adjacent to
a water tap and a water drain.
2. Make sure that the dimensions
of the recess agree with the di-
mensions in the figure.
3. Remove the rear screws (1).
4. Pull the worktop from behind
(2).
5. Lift the worktop and move it
from the front slots. (3)
6. Level the appliance using the
adjustable feet.
7.
Install the appliance under the
kitchen counter.
12.2 Water connection
Water inlet hose
Connect the inlet hose to a water tap with
an external BSP thread spout of 3/4".
For best washing performance it is rec-
ommended to connect the appliance to a
cold water supply.
ENGLISH 19