Daily Use - Electrolux ESF 6700ROW User Manual

7. DAILY USE

1. Open the water tap.
2. Press the on/off button to activate the
appliance. Make sure that the appli-
ance is in setting mode, refer to "Set-
ting and starting a program".
• If the salt indicator is on, fill the salt
container.
• If the rinse aid indicator is on, fill the
rinse aid dispenser.
7.1 Using the detergent
A
7.2 Setting and starting a
program
The Auto Off function
To decrease the energy consumption, this
function automatically deactivates the ap-
pliance a few minutes after:
• You have not closed the door.
• You have not pressed Start to start the
program.
• The program is completed.
Setting mode
For some settings it is necessary that the
appliance is in setting mode.
The appliance is in setting mode when,
after the activation, the indicator and the
duration of program ECO come on.
If the control panel does not show this
condition, press Reset.
B
30
A
20
+ -
C
3. Load the baskets.
4. Add the detergent.
• If you use the multi-tablets, activate
the Multitab option.
5. Set and start the correct program for
the type of load and the degree of soil.
1.
Press the release button (B) to open
the lid (C).
2. Put the detergent in the compartment
(A) .
3. If the program has a prewash phase,
put a small quantity of detergent on
the inner part of the appliance door.
4. If you use detergent tablets, put the
tablet in the compartment (A).
5.
Close the lid. Make sure that the re-
lease button locks into position.
Starting a program without delay
start
1. Press the on/off button to activate the
appliance. Make sure that the appli-
ance is in setting mode.
2. Close the appliance door.
3. Set a program. Press Program again
and again until the indicator of the pro-
gram you want to set comes on. You
can also set the applicable options.
• If you want to set the MyFavourite
program, press MyFavourite. The
indicators that are related to the My-
Favourite program and options
come on.
The display shows the duration of the
program.
4. Press Start to start the program.
• When the program starts, only the
program duration and the program
bar are visible. If you want to see
which program and options are set,
press any touchpad (not Reset). The
set program and options are visible
for a few seconds.
ENGLISH 13