Preset Tuning - Harman Kardon DPR 2005 Owner's Manual

Multiroom Operation
4. Stations may also be tuned directly by press-
ing the Direct button J, and then pressing
the Numeric Keys H that correspond to the
station's frequency. Note that for entering num-
bers higher than 100 you need to enter only the
"1" rather than "10", the first "0" will be
added automatically. The desired station will
automatically be tuned after the latest number is
entered. If you press an incorrect button while
entering a direct frequency, press the Clear
button X to start over.
NOTE: When the FM reception of a stereo
station is weak, audio quality will be increased
by switching to Mono mode by pressing the
Tuner Mode button I on the remote or hold-
ing the Band Selector ! on the front panel so
that appears momentarily in the
MANUAL
Main Information Display ˜ and then goes
out.
44 MULTIROOM OPERATION

Preset Tuning

Using the remote, up to 30 stations may be
stored in the DPR's memory for easy recall using
the front panel controls or the remote.
To enter a station into the memory, first tune the
station using the steps outlined above. Then:
1. Press the Memory button Y on the
remote. Note that two underscore lines will
appear in the Main Information Display ˜.
2. Within five seconds, press the Numeric
Keys H corresponding to the location where
you wish to store this station's frequency. Once
entered, the preset number will appear in the
Main Information Display ˜.
3. Repeat the process after tuning any additional
stations to be preset.
Recalling Preset Stations
• To manually select a station previously entered
in the preset memory, press the Numeric Keys
H that correspond to the desired station's
memory location.
• To manually tune through the list of stored
preset stations one by one, press the Preset
Stations Selector buttons # W on the
front panel or remote.