Harman Kardon DPR 2005 Owner's Manual page 30

System Configuration
may be different with each surround mode, or to
increase or decrease the level of certain speakers
intentionally, depending on the surround mode
selected.
Note: Output level adjustment is not available
for the VMAx or Surround Off mode, as no
surround speakers are used (so level differences
between the speakers in the room cannot occur).
But to compensate level differences between
stereo, VMAx and other surround modes (inde-
pendently from the input selected) the outputs
can be adjusted with the Level Trim Adjustment
procedure, see page 38, also for the Surround
Off (Stereo) and VMAx modes.
Once the settings outlined on the previous pages
have been made, the DPR is ready for operation.
While there are some additional settings to be
made, these are best done after you have had an
opportunity to listen to a variety of sources and
different kinds of program material. These
advanced settings are described on pages 40 to
41 of this manual. In addition, any of the set-
tings made in the initial configuration of the unit
may be changed at any time. As you add new or
different sources or speakers, or if you wish to
change a setting to better reflect your listening
taste, simply follow the instructions for changing
the settings for that parameter as shown in this
section.
Note that any settings changed at any time, also
when the discrete buttons are used only, will be
stored in memory in the DPR, also if it´s turned
off completely, unless it will be reset (see page
56).
Having completed the setup and configuration
process for your DPR, you are about to experi-
ence the finest in music and home-theater listen-
ing. Enjoy!
30 SYSTEM CONFIGURATION