Basic Tuner Operation; Station Selection - Harman Kardon DPR 2005 Owner's Manual

Multiroom Operation
changes the station, the change will also impact
the remote room.
To activate the feed to the remote room, press
the Multiroom button c on the remote. Next,
press the Set button F. Press the
tons E to turn the multiroom feed on or off.
When the multiroom system is on, the Main
Information Display ˜ or OSD will display
MULTI O N. Press the Set button F twice
to enter the setting.
IMPORTANT NOTE: When an A-BUS module is
connected, the DPR's Multiroom system must be
turned on before the A-BUS module is able to
communicate with the DPR. Once turned on
using the instructions in the preceding para-
graph, the Multiroom system must remain on in
order for the A-BUS module to operate.
When the unit is in the Standby mode, but ready
for Multiroom or A-BUS operation, the lighting
around the Standby/On Switch 3 remains
blue and a message appears in the
MULTI O N
Lower Display Line ˜, even though the unit
is "off" in the main listening room.
When the multiroom system is turned on, the
input selected using the Multiroom Menu will be
fed to the Multiroom Output jacks 7 on the
rear panel as well as the A-BUS Jack 8.
The volume will be as set in the same menu,
although it may also be adjusted using an option-
al IR sensor and the Zone II remote in the remote
location or on the optional audio power amplifier
connected to the Multiroom Output jacks 7.
Although changes to the input source or remote
room volume will normally be made using an IR
sensor in the remote room that is connected to
the DPR, it is also possible to change those set-
tings from the main listening room. This is useful
for situations where some or all of the remote
rooms do not have an IR sensor, or to take con-
trol over the remote room without actually being
in that room.
In addition to using the
MULTIROOM
as shown on the previous page, you may change
the source or volume in the remote zone using
the remote. Press the Multiroom Button c
on the remote, and when the
MULTI
message appears in the on-screen
ON/OFF
display and the Lower Display Line ˜, press
the Set Button F and then press the
Navigation Button E to toggle past
/
⁄ ¤
that message to
MULTI LEVEL
.
MULTI INPUT
To change the remote room's input source,
when
MULTI INPUT
Set Button F, and then press the
Navigation Button E until the desired input
appears in the on-screen display and in the
but-
/
⁄ ¤
Lower Display Line ˜.
To change the remote room's volume, when
MULTI LEVEL
Button F, and press the
Button E to change the volume setting. Note
that this volume adjustment controls the level for
the output to the Multiroom Audio Outputs
7 and for any speakers connected to the
Surround Back/Multiroom Speaker Outputs
c when the Surround Back amplifier channels
are configured for Multiroom use, as shown on
page 40. This adjustment does NOT change the
volume level for any room where an ABUS mod-
ule is used, as that setting is only adjustable
using the A-BUS module's volume control or
built-in IR sensor.
Once the multiroom system is turned on, it will
remain on even if the DPR is placed in the
Standby mode in the main room by pressing the
Power Off Button 0 or the System Power
Control 2 on the front panel. To turn off the
multiroom system from the main listening room,
when the DPR is on press the Multiroom button
c and then the Set button F.
buttons E so that the Main
Press the
⁄ / ¤
Information Display ˜ or OSD will display
.
MULTI OFF
Even when the DPR is turned off (to Standby
mode) and the multiroom system is turned off
too, the multiroom system may be turned on at
any time by pressing the Multiroom button
c, or any of the Selector buttons ∫ç
∂ in the remote room.
NOTES ON MULTIROOM OPERATION:
• The Zone II remote does not contain a button
for the front-panel Video 5 input, but you may
select that source for the Multiroom system using
menu,
the
MULTI-ROOM SETUP
optional remote that has been programmed with
the code for the Video 5 button from the DPR's
main remote control.
or
• In addition to the Zone II remote supplied with
appears, press the your DPR, you may use the main remote control
or any remote programmed with Harman Kardon
/
⁄ ¤
codes. Note, however, that only the remote codes
applicable to the remote room system or the
operation of source devices will function. Buttons
used to change other "Main Room" listening
functions such as surround mode changes will
appears, press the Set
not work with the multiroom system.
Navigation
/
⁄ ¤

Basic Tuner Operation

The DPR's tuner is capable of tuning AM, FM and
FM Stereo broadcast stations and receiving RDS
data. Stations may be tuned manually, or they
may be stored as favorite station presets and
recalled from a 30 position memory.

Station Selection

1. Press the AM/FM Tuner Select button 6
on the remote to select the tuner as an input. The
tuner may be selected from the front panel by
either pressing the Input Source Selector %
until the tuner is active or by pressing the Tuner
Band Selector ! at any time.
2. Press the AM/FM Tuner Select button 6
or Tuner Band Selector ! again to switch
between AM and FM so that the desired
frequency band is selected.
3. Press the Tuner Mode button I on the
remote or hold the Band Selector ! on the
front panel pressed for 3 seconds to select
manual or automatic tuning.
When the button is pressed so that
appears in the Main Information Display ˜
each press of the Tuning Selectors 8K will
put the tuner in a scan mode that seeks the next
higher or lower frequency station with accept-
able signal strength. An
indication will momentarily appear when the sta-
tion stops at a stereo FM station, and an
TUNED
when an AM or monaural FM station is tuned.
menu or an
Press the Tuning buttons again to scan to the
next receivable station.
When the button is pressed so that
appears in the Main Information Display ˜
each tap of the Selector will increased or
decrease the frequency by one increment. When
the tuner receives a strong enough signal for
adequate reception,
appear in the Main Information Display ˜.
AUTO
AUTO S T TUNED
AUTO
indication will momentarily appear
MANUAL
will
MANAUL TUNED
MULTIROOM OPERATION 43