To Change Ping Speed; To Adjust Sensitivity; To Turn Off Hyperscroll; Pop-Up Help - Lowrance X96 Installation And Operation Instructions Manual

Ping Speed command on the Sonar Menu (left).
Ping Speed Control Bar (right) at default setting.

To change Ping Speed:

1. From the Sonar Page, press
2. The Ping Speed Control Bar appears. Press ↑ to increase ping speed or
press↓ to decrease ping speed. When it's set at the desired level, press
.
EXIT

To adjust Sensitivity:

1. From the Sonar Page, press
2. The Sensitivity Control Bar appears. Press ↓ to decrease sensitivity
or press ↑ to increase sensitivity. When it's set at the desired level,
press . (When you reach the maximum or minimum limit, a tone
EXIT
sounds.)

To turn off HyperScroll:

1. From the Sonar Page, press
2. The Ping Speed Control Bar appears. Press ↓ to decrease ping speed
to 50 percent. When it's set at the desired level, press
When you boost ping speed and switch into HyperScroll, the width of
the FasTrack bar graph display doubles in width at the right side of the
screen. The allows you to better see the virtually instantaneous sonar
returns, just as you would on a flasher sonar unit. For more
information on FasTrack, see it's entry in this section.

Pop-up Help

Help is available for most all of the menu labels on this unit. By
highlighting a menu item and leaving it highlighted for a few seconds, a
pop-up message appears that describes the function of the menu item.
This feature is on by default.
|↓ to
MENU P
ING
| .
MENU ENT
|↓ to
MENU P
ING
56
| .
S ENT
PEED
| .
S ENT
PEED
.
EXIT