Shoot-Thru-Hull Installation - Lowrance X96 Installation And Operation Instructions Manual

If not, then mark the location that gave you the best sonar returns and
read through the instructions on the following pages for shoot-thru-hull
mounting.
Transducer location
(high speed)

Shoot-thru-hull Installation

1. Make sure the area is clean, dry and free of oil or grease, then sand
both the inside surface of the hull and the face of the transducer with
100 grit sandpaper. The surface of the hull must be flat so the entire
transducer face is in contact with the hull prior to bonding.
Sand this surface
2. Follow the instructions on the epoxy package and mix it thoroughly.
Do not mix it too fast, because it will cause bubbles to form in the
epoxy. Apply a small amount on the face of the transducer as shown
above, then spread a small amount onto the sanded area on the hull.
Shoot-thru-hull transducer locations for
high speed or trolling speed operation.
Epoxy transducer to hull.
Transducer location
(trolling speed)
Spread epoxy here
17