Depth Alarms; Shallow Alarm - Lowrance X86 DS Installation And Operation Instructions Manual

Depth Alarms

The depth alarms are triggered only by the bottom signal. No other
echoes will activate these alarms. The depth alarms consist of a shal-
low and a deep alarm. The shallow alarm sounds an alarm when your
vessel enters water that is more shallow than the alarm's setting. The
deep alarm sounds a tone your vessel enters water that is deeper than
the alarm's setting.

Shallow Alarm

To set the shallow alarm depth, repeatedly press
appears.
A
LARM
Shallow Alarm menu (left). Shallow Alarm Value Dialog box (right).
Press to
↓
S
ET
Use ↑ ↓ to enter the first number in the dialog box, then press
to move to the next digit. Repeat those steps until the desired
DOWN
depth has been entered in the dialog box. To move the cursor back to
any of the previously entered numbers, press
return to the Shallow Alarm menu. Use
on the alarm, then press
ters water more shallow than the alarm's setting, an alarm will sound
and a message will appear on the screen.
Press to silence the alarm. It will remain silent until it is trig-
PWR
gered again.
To turn off the alarm, repeatedly press
menu appears. Press
. The Shallow Alarm Value dialog box will appear.
V
ALUE
PWR
to
↓
O
FF
↑
to clear the menu. When your vessel en-
MENU
, then press
PWR
38
MENU
. Press
MENU UP
to select , which will turn
O
N
until the
to clear the menu.
until
S
HALLOW
MENU
to
PWR
S A
HALLOW LARM