Ifinder  Huntc Quick Reference - Lowrance iFINDER Hunt Operation Instructions Manual

Handheld color gps receiver
Hide thumbs Also See for Lowrance iFINDER Hunt:
Table of Contents

Advertisement

iFINDER
Start outdoors, with a clear view of the open sky. As you practice, try
navigating to a location a few blocks away. Navigation in too small a
space, like a backyard, will constantly trigger arrival alarms.
1. Install two AA batteries (and MMC card if desired) in the battery
compartment on back of case. (See installation on page 11.)
2. To turn on the iFINDER HUNTc, press and release the
3. Opening screen displays map of North America at the 4,000-mile
zoom range. Rotate through the two main Page screens (Map Page and
Compass Page) by repeatedly pressing
4. Wait while unit locates satellites and calculates current position. Flash-
ing question mark or data boxes indicate a position has not been deter-
mined. Position calculation takes an average of one minute or less under
clear sky conditions (unobstructed by terrain or structures.) When position
is found, a tone sounds, a position-acquired message appears, data boxes
stop flashing and the flashing question mark disappears.
5. With position acquired, the Map Page shows your location on the
map in a bird's eye view of the earth. You can move around the map by:
Zoom in closer to see greater detail: press
Zoom out to see more area, less detail: press
Scroll map north, south, east or west using arrow keys ↑ ↓ → ←.
To stop scrolling and return to current position on map, press
6. Set a Vehicle waypoint at your current position so you can navigate
back to your vehicle: press
the waypoint list, then press|
pear on the map.
7. Zoom/scroll map to find a nearby object or location. Use arrow keys to
center the cursor crosshairs over the map object or location.
8. To navigate to the selected location: press
press
|
ENT
EXIT
arrow on Compass Page.
9. At destination, Arrival Alarm goes off. To clear it, press
Cancel navigation: press
|
.
Y
ENT
ES
10. Navigate back home: Zoom/scroll map and use arrow keys to center
cursor crosshair over waypoint Vehicle (1). Press
and press
C
URSOR
11. Back home, Arrival Alarm goes off; press
press
|↓ to
MENU
12. To turn off the iFINDER, press and hold
HUNTc Quick Reference
ENT
. Follow steering arrow on Map Page or compass bearing
MENU
|
.
ENT
EXIT
C
N
ANCEL
AVIGATION
PAGES
↓ ↑
and use the
. Waypoint Vehicle(1) will ap-
|
ENT
ENT
MENU
|↓ to
C
ANCEL
|
|← to
ENT
PWR
126
PWR
.
(zoom in key.)
ZIN
(zoom out key.)
ZOUT
to highlight
, select
G
T
O
O
N
AVIGATION
, select
MENU
. Cancel navigation:
EXIT
|
.
Y
ENT
ES
key for three seconds.
key.
key.
EXIT
from
V
EHICLE
and
C
URSOR
. To
EXIT
|
|← to
ENT
G
T
O
O

Advertisement

Table of Contents
loading

This manual is also suitable for:

Ifinder hunt c

Table of Contents