Table of Contents
Advertisement
Our remote starter is delivered with factory default settings. You can install it without programming or you can modify the
configuration to suit your customer's need. Important: the installation must be completed before accessing
programming mode.
Programming the system:
1. Turn the ignition 3 times OFF to ON and leave the key in the ON position (engine not running).
2. Within 15 seconds, push 1 time on the antenna button. You will hear 5 beeps to confirm that the system is now in
programming mode. The L.E.D. built-in receiver will flash slowly.
Note:
If the 15 seconds delay has expired, just turn the ignition OFF and repeat steps 1 and 2.
The system has 25 programmable options and there are 1 to 3 different possibilities to modify. (Except option #21 &
#22).
Step 1
Press then release antenna button to select option 1 to 25 (depend on models, see programming chart).
Every time you press on receiver button you will hear one beep. Count the beep to reach desired option.
Step 2
When you have reached the desired option depress brake pedal to confirm.
Step 3
Press button
will hear 1 beep,
Depress brake pedal again and count the beep to confirm that the feature has been changed.
Note: if you have more than one option to modify, repeat steps 1 to 3.
Step 4
When finished, Turn ignition OFF to exit programming mode. One long beep will be emitted.
PROGRAMMING
,
or
on transmitter to choose between different possibilities (
to select column 2, you will hear 2 beeps or
to select column 3, you will hear 3 beeps).
8
to select column 1, you
Advertisement
Table of Contents
