Table of Contents
Advertisement
SELECTING AUTOMATIC OR MANUAL TRANSMISSION:
The system can be used for Manual or automatic transmission.
MANUAL TRANSMISSION:
The factory default is set to "Manual". The orange jumper is
NOT CUT and programming option # 3 is on "Manual".
AUTO TACH LEARNING:
After completing the installation, the system must learn the TACH signal before it can start by remote transmitter. Start the
engine with the key, the LED on the antenna will flash if a proper Tach signal is detected. After ~30 seconds, the parking
lights will flash and the system will beep twice to indicate that the TACH signal was recorded. If this operation is not
performed, you can not start the vehicle by the remote transmitter.
Tach learn is performed only one time. This means if you want the Tach signal to relearn, you should program option # 3
for a factory default setting. Most of the time, after the Tach learns the signal, the vehicle will remote start properly.
However, some vehicles require adjusting the Tach signal or cranking time. In this case, you can access option #1 to make
a Tach fine tuning or option #2 to make a cranking adjustment.
Note:
If TACH LED does not flash when Tach learning is performed, it may be necessary to connect to a
different Tach source.
VALET MODE:
Turn the ignition key to ON position. Push and hold the receiver button for 5 seconds to enter into valet mode. You have 15
seconds to do this operation. The system will chirp 3 times and the receiver's L.E.D. will stay solid.
To remove valet mode, repeat the same operation. The system will chirp 1 time and the receiver L.E.D. will turn OFF.
FIRST STEP INSTALLATION
7
AUTOMATIC TRANSMISSION
CUT the orange jumper before power ON the module,
then program option # 3 to "Automatic".
Advertisement
Table of Contents
