Resetting Your Heos Device - Denon HEOS Amp Owner's Manual

Contents

Resetting Your HEOS Device

Resetting your HEOS device will clear out the wireless network info, EQ, and name but retain it's current software. You will have to
use Settings - Add Device to reconnect the HEOS device to your home network before it can be used.
To reset your HEOS device, gently insert a small paperclip into the Reset button hole on the back and hold it in until the front LED
begins to flash amber.
Restoring the HEOS Device to Factory Defaults
Restoring the HEOS device to its factory defaults will clear all of the settings and restore the original software which was installed
at the factory.
Caution
All settings will be erased and the software will likely be downgraded!
To restore your HEOS device to the factory defaults, unplug the power cable from the back of the HEOS device. Insert a small
paperclip into the Reset button hole on the back of the HEOS device, reconnect the power cable, and hold it in until the front LED
begins to flash amber.
* For further information, please visit HEOSbyDenon.com
Setup Use
Solution
Solution
Troubleshooting
48
Status LED Appendix
Refer to Page
Refer to Page
–
–