My Heos Device Turns Off And The Status Led Flashes In Red - Denon HEOS Amp Owner's Manual

Contents

My HEOS device turns off and the status LED flashes in red

The protection circuit has been activated due to a rise in temperature within your HEOS device. Turn the power off, wait about
0
an hour until this device cools down sufficiently, and then turn the power on again.
Check the speaker connections. The protection circuit may have been activated because speaker cable core wires came in
0
contact with each other or a core wire was disconnected from the connector and came in contact with the rear panel of this
device. After unplugging the power cord, take corrective action such as firmly re-twisting the core wire or taking care of the
connector, and then reconnect the wire.
Setup Use
Solution
Troubleshooting
45
Status LED Appendix
Refer to Page
–
13