Qualcast GLM3300 Operating Instructions Manual page 3

o) Stop the motor and disconnect the plug
from the mains
- Before clearing blockages or unclogging
chute;
- Before checking, cleaning or working on
the lawnmower;
- After striking a foreign object, Inspect
the lawnmower for damage and make
repairs before restarting and operating
the lawnmower;
- If lawnmower starts to vibrate abnormally
(check immediately);
t) Stop the motor, -whenever you leave the
lawnmower;
v) Go slow when using a trailing seat.
Maintenance and storage
a) Keep all nuts, bolts and screws tight to
be sure the equipment is in safe working
condition;
b) Check the grass catcher frequently for
wear or deterioration;
c) Replace worn or damaged parts for
safety;
WARNING:
- Not to use the lawnmower if the cords are
damaged or worn.
- Not to connect a damaged cord to the
supply or touch a damaged cord before
it is disconnected from the supply. A
damaged cord can lead to contact with
live parts.
- Not to touch the blades before the
machine is disconnected from the
supply and the blades have come to a
complete stop.
- To keep extension cords away from the
blades. The blades can cause damage
to the cords and lead to contact with live
parts.
- To disconnect the supply (i.e, pulling the
plug from the socket)
- Whenever leaving the machine
unattended,
- Before clearing a blockage,
- Before checking, cleaning or working on
the machine,
- After striking a foreign object,
- Whenever the machine starts vibrating
1200 Watt
Electric rotary Mower
Original instructiOns
-
-
-
syMBOls
abnormally.
To carefully read the instructions for the
safe operation of the machine;
Recommendations:
Always connect the appliance to a supply
circuit protected by a residual current
device (RCD) with a tripping current of not
more than 30mA.
Warning!
Read the operator's manual.
Beware of sharp tines. Tines
continue to rotate after the
motor is switched off – remove
plug from mains before
maintenance or if cord is
damaged.
Keep bystanders away
Keep supply flexible cord away
from the tines
Blade continues to rotate after
the machine is switched off. Wait
until all machines components
have completely stopped before
touching them.
WEEE marking
HElPlinE nO 0844 8010979