Spot Monitor; Figure 39: Display - Spot Monitor Setup Screen - Falcon 960H User Manual

User's Manual
You can adjust the display dwell time by highlighting the box beside Interval and pressing the
select dwell intervals ranging from 1 second to 1 minute.
Highlight Event Monitoring On and press the
it is On, the DVR will display the camera associated with the event when an event occurs.
Highlight the box beside Resolution and press the
for NTSC video, and 1280x1024, 1440x900 and 1920x1080 (@ 60Hz or 50Hz) for PAL video.
NOTE: When the individual main monitors are connected to the HDMI and VGA connectors for simultaneous
operation, it is recommended to use monitors supported with the same resolution. If monitors unsupported
with the same resolution are connected, video cannot be displayed on the monitor with the resolution
you have set.
Highlight Fit To Screen and press the
the DVR will resize video to fit the main monitor screen.

Spot Monitor

Highlight the box in the Channels column and press the
You can define which cameras display sequentially on the Spot Monitor when in the single-screen display format.
Highlighting the box under the Camera and pressing the
You can adjust the display dwell time by highlighting the box under the Dwell and pressing the
select dwell intervals ranging from 1 to 20 seconds.
NOTE: Refer to Chapter 3 – Configuration – Spot Monitoring for spot monitor display options.
52
button. Pressing the
button. You can select from 1280x1024, 1440x900 and 1920x1080
button. Pressing the
Figure 39: Display – Spot Monitor setup screen.
button.
button toggles between On and Off.
button toggles between On and Off. When
button toggles between On and Off. When it is On,
button. You can
button. You can