Falcon 960H User Manual page 50

User's Manual
CAUTION: When changing the port settings, you must change the port settings on the PC running
ATVision as well. Refer to the ATVision manual for details.
Highlight Use UPnP and press the
NAT (Network Address Translation) device to the DVR will be enabled automatically via UPnP (Universal Plug and
Play) service. This function will be especially useful when accessing a port on a private IP address.
NOTE: For the UPnP service to work, the NAT device should support the UPnP Port Forwarding function and
the function should be set to enabled.
You cannot change the port settings when Use UPnP is On.
Highlight the Status box and press the
service.
Highlight the Test box and press the
Selecting DHCP from the Type and highlighting Save button reads the current IP address of the DVR configured by
DHCP (Dynamic Host Configuration Protocol) network.
Highlight Auto (Default) and press the
the IP address of the DNS server automatically.
NOTE: Selecting Auto will only be enabled when the DVR is configured for DHCP or an ADSL network.
Selecting ADSL (with PPPoE) allows you to set up the ADSL network.
Highlight the box beside ID and press the
connection.
Highlight the box beside Password and press the
password for ADSL connection.
NOTE: Entering the ID and Password and highlighting OK reads the current IP address of the DVR configured
by the ADSL network.
If the DVR is configured for DHCP or an ADSL network, the IP address of the DVR might change whenever
the unit is turned on.
42
button to toggle between On and Off. When it is On, port forwarding from the
button to display the port numbers forwarded from the NAT device via UPnP
button to test the current LAN settings you made.
button to toggle between On and Off. When it is On, the DVR will obtain
button. A virtual keyboard appears allowing you to enter the ID for ADSL
button. A virtual keyboard appears allowing you to enter the