Digital Monitoring Products XR150 User Manual page 43

ACCESS SCHEDULES
This option allows you to assign up to eight Schedules to a
profile for door access. When the keypad displays FIRST ACCESS
SCHEDULE: - press any of the first three Select keys to enter the
desired Schedule number. Press the fourth Select key to browse
available Schedules in the LIST option. Press the Select key under
the desired Schedule to display the Schedule number then press
COMMAND. The keypad displays SECOND ACCESS SCHEDULE: -
repeat the same process for the third through eighth access
schedule and press COMMAND to return to the User Menu.
Note: T o program a profile with anytime access, do not assign the
profile number to any Schedules.
RE ARM DELAY
RE ARM DELAY allows the entry of 0 to 720 minutes to be used to
delay automatic rearming when the user disarms an area outside
of schedule. If zero is selected, the rearming occurs based on
permanent programming in the panel. If another user enters a
valid user code or credential after the RE ARM DELAY countdown
has started, and their user profile RE ARM DELAY is greater, then
the RE ARM DELAY countdown starts over with the new time.
RE ARM DELAY is also used to delay a late to close message to the
central station when the panel does not use automatic arming.
If the user has Extend Schedule authority, 2HR 4HR 6HR 8HR
displays at disarming. If the user does not make a choice, the
RE ARM DELAY is used to extend the schedule.
Application example: An exit door near the trash is scheduled
to be armed at all times. When the custodian needs to remove
trash, program 10 minutes for the activity. Or, an overhead door
only requires access when a delivery is made. Program up to 720
minutes to allow the loading dock supervisor to load or unload a
semi-truck.
User Menu
EASY ARM/DISARM?
When entering your code, Easy Arm/Disarm allows you to
automatically arm or disarm all areas that are assigned to your
code. The ALL NO YES? option does not display when this option is
enabled.
USE SECONDARY LANGUAGE
This option allows you to set the programmed secondary user
language to display when the Easy Arm/Disarm option is enabled
and the user presents their credential or enters their user code at
the Status List.
CARD PLUS PIN
For a Profile using Card Plus PIN, two code entries are required
by a user to operate the system from a keypad. The first must
be
entered from a proximity patch, credential card, fob, etc., on
a keypad with a built-in or external reader. The second code is a
PIN number keyed in at the keypad or can be a second credential.
Select YES to require users in this Profile to present a proximity
credential and enter a PIN number wherever user code entry is
required for system functions accessed from a keypad. Select
NO to disable Card Plus PIN operation. Default is NO.
If any profile assigned to a user has Card Plus PIN enabled, the user
will be required to enter their user code and PIN to Arm/Disarm
or to perform a door access for the areas assigned to that profile.
If all profiles assigned to a user have Card Plus PIN enabled, the
user will be required to enter their user code and PIN to access the
user menu.
Note: W hen enabled, all existing user codes assigned to the profile
will need a PIN number assigned.
Note: The Card Plus PIN option is only available on Area systems.
XR150/XR350/XR550 User Guide 39