Digital Monitoring Products XR150 User Manual page 17

If your Area system is setup with nine or higher areas and the
system is armed, the display reads: ALL SYSTEM ON or SYSTEM ON.
Refer to Checking Armed Areas for information about checking the
armed areas.
If your system is set up as a Home/Sleep/Away or All/Perimeter
system, one of the following displays indicate the current Armed
Status:
The keypad displays When
HOME SYSTEM ON
The perimeter is armed in a Home/
Sleep/Away system.
PERIMETER ON The perimeter is armed in an All/
Perimeter system.
ALL SYSTEM ON
All areas are armed.
SLEEP SYSTEM ON
The perimeter and interior are armed
but the bedroom area is disarmed.
If your system is set up as a Home/Sleep/Away with Guest system,
the arming status of the main system is the same as a standard
Home/Sleep/Away system. The current arming status of the Guest
systems displays as follows:
The keypad displays When
HOME GUEST 1 ON The first guest house perimeter is
armed in a Home/Sleep/Away with
Guest system.
SLEEP GUEST 1 ON
The first guest house perimeter and
interior are armed but the bedroom
area is disarmed.
ALL GUEST 1 ON All first guest house areas are armed.
Note: The XR150 system allows one guest house system while the
XR350 and XR550 allows two guest house systems.
Introduction
Also, for keypads that include an Armed LED, the Armed LED is ON
steady when ALL areas assigned to that keypad are armed and OFF
when any area assigned to that keypad is disarmed.
View Zone Status
To view disarmed zones that are in fault, press any Select key
when the status list displays.
Browser Feature
Refer to Appendix B at the back of this guide for diagrams showing
you how to use the built-in browsers.
XR150/XR350/XR550 User Guide 13