Table of Contents
Advertisement
Graphic Touchscreen Keypads: Set the backlight illumination and
AC Power/Armed LED brightness level. In the touchscreen display
below SET BRIGHTNESS, press the left < to lower and the right > to
raise the backlight brightness. If the brightness level is lowered,
it reverts to maximum intensity whenever the screen is pressed
during normal operation. If the screen is not pressed, and the
speaker has not sounded for 30 seconds, the user-selected standby
brightness level restores.
Internal Speaker Tone
Set the tone of the keypad internal speaker. At the SET TONE
display, use the top left Select key to make the tone lower. Use the
right Select key to make the tone higher.
Volume level
Set the volume level of the keypad internal speaker for key
presses. During alarm, trouble, and prewarn conditions, the
volume is always at maximum level. At SET VOLUME LEVEL, use the
left Select key to lower the keypad volume. Use the right Select
key to raise the volume.
Model Number
Thinline™,
Aqualite™,
Graphic Touchscreen Keypads:
The keypad model number, firmware version, and date display, but
cannot be changed.
Serial Number
Thinline™ Wireless Keypads:
The serial number assigned to the keypad displays. Press the Back
Arrow key to exit the User Options function.
Keypad Address
The current address assigned to the keypad displays, but cannot
be changed. Press the Back Arrow key to exit the User Options
function.
8
Wireless,
Clear
Touch,
XR150/XR350/XR550 User Guide
Special Keypad Tones
Your keypad also contains a small speaker that alerts you about
events as they occur on your system. For burglary alarms, as soon
as the first digit key is pressed to enter a user code, the keypad
tone stops. If a valid user code is not entered or an invalid user
code is entered within five seconds, the tone begins sounding
again. Below are brief descriptions of the different tones you hear
from the keypad.
Fire Alarm tone: A sweeping siren that sounds until the fire alarm
is silenced.
Burglary Alarm tone: A constant siren tone that continues until
the alarm is silenced.
Key press tone: A short beep each time you press a key on the
keypad and it is acknowledged by the system.
Prewarn tone: A pulsed tone that sounds when you open an entry
delay door on a system that is armed (turned on) reminding you
to disarm the burglary protection. The tone silences as soon as
the first user code digit key is pressed. If a valid user code is not
entered or an invalid user code is entered within five seconds, the
prewarn tone begins sounding again.
and
Exit tone: A pulsing tone that sounds during the exit countdown
just after arming all areas of your system to remind you to exit the
premise. At ten seconds prior to the end of the countdown, the
rate of pulsing increases.
Monitor tone: A pulsed tone for one second, one pulse only that
sounds whenever a door or window is opened while you are using
the zone monitor function from the User Menu. See Zone Monitor.
Note: When toggling to a RMV monitor state, the Zone Monitor
tone does not sound.
Introduction
Advertisement
Table of Contents
