Table of Contents
Advertisement
About the controls and settings.
Setting the Temperature Control
Display Panel
When the Wine Chiller is Plugged In
After plugging in the wine chiller and making your
temperature selection, allow the wine chiller to
reach the set temperature before loading your
wine . This may take up to 12 hours to completely
stabilize .
After loading the wine, you may notice a rise
in the temperature . Allow adequate time for
the temperature to return back to the set
temperature . This may take up to 12 hours to
completely stabilize .
Switching of the Fahrenheit temperature and Celsius temperature
Press the Light key and the Power key
at the same time for 3 seconds to switch
between Celsius temperature and Fahrenheit
NOTE: WHEN MIXING ANY COMPARTMENT FOR BOTH RED WINE AND WHITE WINE STORAGE,
WE RECOMMEND THAT YOU PLACE RED WINE BOTTLES ON TOP SHELF AND WHITE WINE ON
BOTTOM SHELF.
Interior Light
On some models, after the power is on for
3 seconds, the lighting turns on by default for
30 seconds . If the lighting key is not operated
within 30 seconds, the lighting will automatically
turn off .
On some models, if there is no key operation
for 30 seconds, the display screen will turn off .
The display screen will turn on again, if you
touch any key .
When powering on, the temperature of the
zones will be adjusted according to the factory
pre-set .
By pressing the Temperature-rise key
temperature will increase 1°C (or °F) .
By pressing the Temperature-drop key
the temperature will decrease 1°C (or °F) .
The upper zone temperature range is 5~12°C,
the lower zone temperature range is 12~18°C .
The factory pre-set temperature is 8/15°C
(upper/lower zones) .
temperature; the screen will display the
Fahrenheit temperature or Celsius temperature
under the current mode .
Press the Light key to turn on or turn off the
light .
GEAppliances.ca
, the
,
5
Advertisement
Table of Contents
