Detachable Blower - RIDGID WD40800 Owner's Manual

Detachable Blower

1. To remove the detachable blower from
the lid assembly, press down on the
detachable blower latch under the
detachable blower handle and lift the
blower off the lid of the Vac.
2. To replace the detachable blower onto
the lid assembly, position detachable
blower above the indented area of the
lid assembly. Rotate the detachable
blower down until the travel of the unit
stops.
3. Lightly press down on the carry handle
of the detachable blower until you hear
the "snap" of the detachable blower
latch engaging the detachable blower.
The detachable blower is now latched
to the lid assembly.
4. Your new Wet/Dry Vac is ready for use.
With the Wet/Dry Vac completely
assembled and ready for use, insert
the push button end of the hose into
the inlet of the Vac. The hose should
snap into place. To remove the hose
from the Vac, press the release button
in the hose assembly and pull the
hose out of the Vac inlet, as shown.
(Power Head Assembly)
Detachable
Blower Carry
Handle
Detachable
Blower
Latch
Detachable
Blower
Lid Assembly
Indented Area (2)
Detachable
Blower Carry
Handle
Detachable
Blower
Latch
Press Then
Push or Pull
Release
Button
7
Vac Inlet
Detachable
Blower
Detachable
Blower