Table of Contents
Advertisement
FUTABA 9Z
V
Stage 2 Reassembly:
1.
Complete in reverse order to disassembly.
2.
Before proceeding you may find it useful to loosen the case sides a little (see photo
below) to provide a tiny amount of slack to allow the case back to snap in more
easily. Be aware that if you loosen the sides too much the top corner covers may
become unseated or fall out. If this happens see Stage 3 instructions.
Figure 60 Screws to loosen to allow play in case sides
3.
Slide the case back over the Module pins in the same way it came off, and slip it
under the top case's lip. As shown in Figure 61, you may need to lever this lip up
slightly with a screwdriver (protect screwdriver end with tape) and this is why we
loosened the top case screws in disassembly. Do not refit or tighten any screws at
this stage!
Warning: Note the position of some large components on the main PCB, the case back
module compartment fits between these so be careful not to crush them. Once the case
back is in place replace its screws.
Warning: Do not pull up on the carrying handle of the 9Z as recommended by some
posters on the internet. The carrying handle is attached to the 9Z metal case frame not
the top panel and will just bend the whole 9Z out of alignment.
WARNING: THE INFORMATION IN THIS MANUAL IS FOR INFORMATION PURPOSES ONLY AND MAY BE INCORRECT, CAUSE DAMAGE
TO YOUR RADIO OR INJURY TO YOURSELF AND OTHERS. IF YOU USE THIS MANUAL YOU DO SO SOLEY AT YOUR OWN RISK.
THE UNOFFICIAL WORKSHOP MANUAL
Page 63 of 84
www.jamesandtracy.co.uk
Copyright 2012 jamesandtracy.co.uk
Advertisement
Table of Contents
