Disabling Receiving Alarms For Routine And Safety Calls - JRC JHS-770S Instruction Manual

Settings & Registrations
5.5.3

Disabling receiving alarms for routine and safety calls

The aural alarm for routine and safety calls can be disabled as follows.
■ ■
Procedure
To disable the receiving alarms for routine and safety calls, set the 3. Safety/Routine ALM
condition to ON with the jog dial.
5.5.4 Medical/Neutral use setting for urgency calls
The following describes the procedure to set the condition so that an urgency all ships call containing the
additional subject of either "Medical transportation" or "Neutral nationality" can be sent.
Additionally, note that this setting will return to the default setting (OFF) if the power is turned off.
■ ■
Procedure
To use these kinds of calls, set the 4. Medical/Neutral use condition to ON with the jog dial.
5.5.5 Expanded MMSI registration
If existing multiple DSC devices having the same 9-digit MMSI on board a ship, setting the 10
number to a non-zero value is available to distinguish them in the case of routine individual calls.
The handling of 10-digit MMSI is as follows.
・ When sending a routine individual call, the caller ID (own ship station's MMSI) will be 10-digit MMSI.
・ When receiving an routine individual call, the DSC having the identical address only will treat the message, i.e.
mainly the DSC having "0" as the 10
・ When sending an acknowledgement to a received individual call, the address of the call will be entered the
caller's ID of the individual call as it is, i.e. if the 10
10-digit MMSI automatically.
■ ■
Procedure
th
To register the 10 digit of own MMSI, set the number to the 5. Expanded MMSI condition with
the numeric keypad or the jog dial.
5-12
th
digit of MMSI will receive a individual call addressed to the own station.
th
digit of the caller's ID is not "0", the address will be
th
digit of the MMSI