Advertisement
19
Fan
white
fuses
black
orange
blue
Green
Make wiring connections as indicated above.
White from fan to white from remote marked
N. Orange from fan to Orange from remote
marked Light/up. Blue from fan to blue from
remote marked down light. Black from fan to
Black from remote marked L. White from
house to white from remote marked AC N .
Black from house to Black from remote
marked AC L. Connect all green ground wires
to Ground wire from House.
22
Remove the finial nut and hex-
nut from fitter.
25
Place the light fitter and tighten with
screws and washers.
28
Reverse function for this fan is a
switch on the top housing of the fan
body. Turn fan off and wait for fan to
stop then flip the switch to reverse
the direction of the blades.
20
House
white
black
Make wire connections to power source using wire
nuts provided. Make sure that no filiments are out-
side of the wirenut. After making the wire connec-
tions, the wires should be spread apart with the
grounded conductor and the equipment-grounding
conductor on one side of the outlet box and
ungrounded conductor on the other side of the outlet
box. The splices after being made should be turned
upward and pushed carefully up into the outlet box.
23
Remove three screws and wash-
ers from light fitter.
26
Install 3 x 40 watt candelabra base
bulbs. Bulbs not included.
29
Remove cover by snaping off from top or bot-
tom. Remove battery cover. Install 12V battery
into wall remote. Duracell MN21 / Eveready A23
/ GP 23A all 12V.Attach cover of remote by
placing over buttons and snap the battery cover
in place.
21
Lift canopy allowing the 2 studs
to protrude through the canopy
and install knurled nuts as shown.
Tighten the knurled nuts securely.
24
Connect white wire from fan to white
wire from light fixture. Then plug
blue wire from fan to black wire from
light fixture.
27
Place glass on fitter, install rubber
washer and hex nut to glass and
then tighten the finial nut securely
by hand.
30
HAND HELD INSTALL
Place face plate over battery compartment and
buttons. Place remote over 2 pins on front
cover. Attach cover of remote by placing over 4
pins and snapping into place.
Advertisement
