Changing The Channels - Sharp LC-15C2HA Operation Manual

BASIC OPERATION (Continued)

Changing the Channels

Changing channels using CHANNEL SELECT on the remote control.
• To handle the increasing number of channels available, this LCD TV set allows you to select up to
100 positions (Channels 0 to 99). One-digit and two-digit methods of selection can be used. Follow
the procedure shown below to select channels.
POWER
DISPLAY
SLEEP BRIGHT
MENU
TV/VIDEO
VOL
CH
-/--
MPX
Changing channels with CH (
Press CH ( ) and the channels change in the order shown below:
1 → 2 → 3 → . . . → 98 → 99 → 0 → 1 → 2 → 3 → . . .
Press CH ( ) and the channels change in the order shown below:
3 → 2 → 1 → 0 → 99 → 98 → . . . → 3 → 2 → 1 → . . .
12
To select a one-digit channel
(e.g., Channel 5):
1
Press the
2
If "5–" is indicated and the picture
does not change, press the
button to switch over to the 1-digit
select mode and press
CH ( )/( )
CHANNEL
SELECT
To select a two-digit channel
(e.g., Channel 15):
1
Press the
2-digit select mode.
2
Press the
3
Press the
Note:
• Complete this procedure within 4
seconds, otherwise the selection will not
be made.
)/( ) on the remote control.
button.
-/--
again.
button to set the
-/--
button.
button.