Installation Of The Su-1 - Vertex Standard VXA-210 Service Manual

Air band transceiver

Hide thumbs Also See for VXA-210:

Operating manual (52 pages)

Service manual (3 pages)

Table of Contents

Enlarged version

1. Make sure that the transceiver is off. Remove the hard

or soft case, if used.

2. Remove the two screws affixing the belt clip and re-

move the belt clip, then remove the battery pack.

3. Locate the connector for the SU-1 under the "Cau-

tion" label in the battery compartment on the back of

the radio, just carefully peel off the "Caution" label.

4. Remove the small Rubber Cushion from the "Cau-

tion" label. Keep this Rubber Cushion for future use,

because this Rubber Cushion must be replaced on the

connector board of the transceiver if you remove the

SU-1 from the transceiver. We recommend that this

Rubber Cushion be put on the bottom of the SU-1.

VERTEX STANDARD CO., LTD.

MADE IN JAPAN

FCC ID:K66VXA-200

ÛÛÛÛÛÛ

CANADA: ÛÛÛÛÛÛÛÛÛ

4909969000000

SER NO. 00000000

CAUTION

Device restricted to occupational use to

satisfy FCC RF exposure compliance.

See owner's manual for specific operat-

ing requirement.

Peel off the CAUTION Label

5. Align the connector on the SU-1 with the transceiver's

6. Affix the "Caution" label, and replace the battery and

7. Installation is now complete.