Mounting Bracket Installation - Vertex Standard VX-4500 Installation Manual

M
ounting
The supplied mounting bracket allows desktop or overhead mounting.
 Use a 7/32 inch (5.5 mm) bit to drill the holes to a surface which is more 0.4
inch (10 mm) thick and can support more than 3.3 lbs (1.5 kg) and secure the
bracket with the supplied screws, spring washers, flat washers, and nuts.
You may secure the bracket using the supplied tapping screws, instead of the
screws and nuts. In this case, drill the small pilot holes instead of the 7/32 inch
(5.5 mm) holes.
 Install the transceiver to the bracket using the supplied Knob Screws and
Washers (or Hex Head Bolts, depending on the situation).
Use only the supplied Knob Screws with Washers, Hex Head Bolts,
or equivalent size screws (HSM5X12).
D M
esktop ount
D M
esktop ount
VX-4500/-4600 T
B
racket
( )
s & n
with crew ut
( )
t s
with apping crew
i
ransceiVer nsTallaTion
i
nstallation
(
o M
verheaD ount with
(
o M
verheaD ount with
G
uide
)
s & n
crew ut
)
t s
apping crew
1