Image Advanced Signal Menu - Optoma EH341 User Manual

USING THE PROJECTOR

Image advanced signal menu

Notee:
‡ "Signal" is only supported in Analog VGA (RGB) signal.
‡ If the "Signal" setting is set to automatic, the phase, frequency items are grayed out. If the "Signal"
setting is set to a specific input source, the phase, frequency items will appear for the user to manually
tune and are saved in the settings after the next time projector is turned off and on again.
Automatic
Automatically selects the signal. If this function is enabled, the Phase, frequency items are grayed out. If this
function is disabled, the phase, frequency items will appear for user to manually tune and saved in settings after the
next time projector turns off and on again.
Phase (VGA)
Synchronize the signal timing of the display with the graphic card. If the image appears to be unstable or flickers,
use this function to correct it.
Frequency (VGA)
Change the display data frequency to match the frequency of your computer's graphic card. Use this function only if
the image appears flickering vertical lines.
H. Position (VGA)
‡ Press the
‡ Press the
34 English
Automatic
Phase
Frequency
H. Position
V. Position
Automatic
Off
Phase
Frequency
to move the image left.
to move the image right.
H. Position
IMAGE
Advanced e: Signal
On
Exit
On