Yaesu FT-410 Operation Manual page 5

F
rOnT
24. SPLIT Button
Press this button to activate split frequency
operation between VFO-A, used for reception
and VFO-B, used for transmission (or vice
versa).
25. MW Button
Pressing this button copies the current operating
data into the currently selected memory channel,
over-writing any previous data stored there.
26. DISP Button
27. A=B Button
Press this button momentarily to transfer data
from VFO-A frequency to VFO-B, overwriting the
previous contents in VFO-B. Use this key to set
both VFO-A and VFO-B to the same frequency
and mode.
28. A/B Button
This button toggles the frequency control
between VFO-A and VFO-B.
29. M-CLR Button
Press this button, a memory channel is cleared.
FT-410 O
peraTiOn
p b
anel
M-012
14.195.000
M
anual
uTTOns and
2425
30. M V Button
Press this button, a frequency and a mode of a
memory channel are forwarded to VFO.
31. SCAN Button
Press this button to initiate the upward scanning
of VFO frequencies or memory channels.
32. VOX Button
Press this button to activate the VOX (voice-
actuated transmitter switching) feature in the
SSB, and AM modes.
33. MODE Button
These buttons select the operating mode.
34. ENT Button
Press this button, setting is Oprating frequency.
35. NR Button
Press this button to activate Noise Reduction
operation
36. NF Button
Press this button to activate Notch Filter
operation.
K
nObs
26 27 28
29
30
31
32
33
34
35 36
Page 5