Troubleshooting - Klauke mini+ EK 50/18-L Instruction Manual

Instruction Manual Crimping Tool
EK 50/18-L
4.4 Service and maintenance instruction
For every day service the tool has to be cleaned and dried after each use. The battery cartridge and the charging unit
have to be protected against humidity and dust.
Attention
Maintain power tools thoroughly. Check for functionality or jamming of moving parts, breakage of parts and
any other condition that may affect the power tools operation.
The electric-hydraulic unit is equipped with a controller enabling the user to see when the next service is due by
fl ashing for 20 sec. at the end of a working cycle. When the next service is due after 10.000 cycles the unit must
be returned to an authorised service center (ASC). Failure to observe this request results in loosing the Warranty.
Preventive maintenance serves your safety. Within the determined use of the tool only thedies are permitted to be
changed by the customers.
Attention
Do not damage the seals of the tool
Attention
Have the power tool repaired by a qualifi ed expert or by a Klauke ASC before use.
5.

Troubleshooting

a.) Constant fl ashing/indicating of the red LED (pic 1.3) or the occurence of an acustical warning signal.
see tab. 1. If the failure can not be resolved through the action recommended in table 1 return the tool to the
nearest service center (ASC).
b.) The tool loses oil.
Return the unit to the manufacturer. Do not open it and damage the seal of the tool.
c.) The red LED fl ashes 3x and simultaneously 3 acoustic warning signals occure (see tab. 1).
Serious fault! If this fault occures repeatedly return the unit to an Autorized Service Center (ASC). Do not open
it and damage the seal of the tool.
In case of a one time occurence the connector has to be pressed a second time.
HE.13438_B © 11/2009 7
GB