New Loose Hardware; New Assembly Procedure; Attach Throttle Control - Troy-Bilt 47260 Owner/Operator Manua

OWNER/OPERATOR MANUAL SUPPLEMENT
Installation and Use Instructions for New Style Engine Throttle Control
(Carefully read this Supplement and then insert it at Page 26 of your TROY-BILT® ChipperNac Manual)
1
You have received a new style Engine Throttle
• Control that replaces the engine ON/OFF switch
that is described in your Manual. Use the infor-
mation on these pages to install and use the new
throttle control and save this Supplement for
future reference.
NEW LOOSE HARDWARE
2.
3.
This Supplement contains important Parts
Catalog information. Be sure to update your
Parts Catalog as described on Page 3.
If
you have any questions or concerns, contact
your local authorized service dealer, or call or
write our Technical Service Department. See
Page 4 for telephone and address information.
NOTE: The two #10-24 x 1/2" self-threading, Hex/Washer Screws (see
Key "N" on Page 9 of your Manual) are no longer required.
FOR MODEL:
4HP 5HP
KEY QTY.
The loose parts hardware bag con-
tains three new parts that are not
shown or listed on Page 9 of your
Manual. These parts will be used
to install the new Throttle Control.
Refer to the table to the right and to
Figure I below to identify these
new parts.
NEW ASSEMBLY PROCEDURE
A
B
C
DESCRIPTION
1 Bracket •
2 Pan Hd. Screw, #10-24 x 2".................................................. •
2 NutiLockwasher, #10-24...................................................... •
•
•
•
The following procedure replaces
Step 3 on Page 10 of your
Owner/Operator Manual.
A. Complete Steps 1 and 2 on
Pages 9 and 10 of your Manual.
B. Place the bracket (A, Fig. 1)
over the lower set of holes on the
left side handlebar as shown (on
the 4HP Model there is only one
set of holes). Make sure the long
side of the bracket is on the out-
side edge of the handlebar.
C. Carefully unwrap the throttle
control cable assembly (D, Fig. 1)
from around the engine. Route the
cable straight back (to the inside of
the left side handlebar support),
and then up along the bottom of
the handlebar.
D. Place the lever assembly on the
outside of the bracket. Install two
pan hd. screws (B) and nut/lock-
washers (C) as shown. Tighten the
hardware securely.
(Continued on Page 2)
Figure 1: Attach throttle control (shown on 5HP Model handlebar).