Safety Decals - Troy-Bilt 47260 Owner/Operator Manua

Safety
MAINTENANCE AND
STORAGE
1. When equipment is stopped for
servicing, inspection, storage, or to
change an attachment or accessory,
make sure the spark plug wire is
disconnected from the spark plug.
Allow the engine to cool before
making any inspections, adjust-
ments, etc.
2. Maintain equipment and all at-
tachments and accessories in a
clean, and safe working condition.
SAFETY DECALS
3. Never perform any maintenance
while the engine is running or when
the spark plug wire is connected to
the spark plug, except where specif-
ically instructed to do so.
4. Never store this equipment with
fuel in the fuel tank inside a build-
ing where fumes may reach an
open flame or spark, or where igni-
tion sources are present such as hot
water and space heaters, furnaces,
clothes dryers, stoves, electric mo-
tors, etc.
5. Allow engine to cool before
storing in any enclosure.
6. Store gasoline in a cool, well-
ventilated area, safely away from
any spark- or flame-producing
equipment. Store gasoline in an
approved container, safely out of
the reach of children.
7. Use only original equipment re-
placement parts. Parts manufac-
tured by others could present a
safety hazard even though they
may fit on this equipment.
8. Store this equipment where
children will not have access to it.
Disconnect the spark plug wire
from the spark plug.
9. Check collection bag frequently
for deterioration or wear and re-
place worn bags. Use only origi-
nal-equipment replacement bags.
Bags manufactured by others could
present safety hazards.
10. Refer to the Engine Owner's
Manual and to "Off Season
Storage" in Section 5 of this
Manual for important storage in-
structions if equipment is to be
stored for an extended period.
Make certain that all safety decals on this equipment are kept clean and in
good condition. The decals are shown (at reduced sizes) below and on the
next page. If you need a replacement decal, please refer to the Parts
Catalog that accompanied this Manual.
ROTATING
CUTTING
BLAOESI
TO AVOID
SERIOUS INJURY:
KEEP HANDS AND
FEET OUT OF
VACUUM INLET
WHEN MACHINE IS
RUNNING.
DO NOT OPERATE
WITHOUT A
VACUUMING
ATTACHMENT OR
VACUUM INLET
CAP INSTALLED.
BEFORE ClEARING
BLOCKAGES,
CHANGING
VACUUMING
ATTACHMENTS,
DR ADJUSTING
FAN COVER, STOP
ENGINE,
DISCONNECT
SPARK PLUG
WIRE, AND WAIT
FOR ALL MOVING
PARTS TO STOP.
1901'.7(1192)
.... ON CHIPPER CHUTE
(FACING HANDLEBARS)
6
.... ON FRONT
OF MACHINE,
ABOVE
VACUUM INLET