1. Manuals
  2. Brands
  3. Alecto Manuals
  4. Baby Monitor
  5. Hesdo DBX-90
  6. Instruction manual

Alecto Hesdo DBX-90 Instruction Manual

Hide thumbs
1
2
3
4
5
6
7

Advertisement

Table of Contents

I
nstruction
M
anual

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the Hesdo DBX-90 and is the answer not in the manual?

Questions and answers

Related Manuals for Alecto Hesdo DBX-90

Summary of Contents for Alecto Hesdo DBX-90

  • Page 1 nstruction anual...

  • Page 2: Power Supply

    POWER SUPPLY Thank you for purchasing our DBX-90 baby monitor. Your unit has been manufactured and checked under the strictest possible quality control (A) Transmitter to ensure that each monitor leaves the factory in perfect condition. In the unlikely event you find any defects or have any problem, please Push until a "click"...

  • Page 3: Controls Layout

    (B) Receiver CONTROLS LAYOUT Push until a "click" sound is heard 1. Operation from battery pack Press down the lock button, slide open the battery cover in the direction as shown. Insert the supplied rechargeable Ni-mH battery pack into the compartment. Make sure the two spring plates are in contact with the two terminals of the battery pack.

  • Page 4: Operation

    OPERATION e. Use Up/Down button 2 to select the Out-of-range alert function. On means this function is enabled while O means this function is disabled. (In case ELo is selected, TRANSMITTER the out-of-range alert function is always On and cannot be set to O .) When set 1.
  • Page 5 4. Place the transmitter about 1 m from the crib with the microphone 5 facing towards b. Use Up/Down button 9 to select a channel same as the transmitter. Each press the baby. of the button will cause the channel no. to advance or retreat one step. Press and hold the Up or Down button 9 will cause the channel no.
  • Page 6 f. Using the Up/Down button 9 , set the lower temperature limit below which the 5. The speaker volume can be adjusted using the Up/Down button 9 . The volume unit will provide a temperature alarm. The allowed selectable temperature range bar graph in the LCD will also change correspondingly.

  • Page 7: Troubleshooting Guide

    TROUBLE SHOOTING GUIDE Problem Possible Causes Solution 11.Each time a button is pressed, a beep tone will be heard to validate your entry being recognized by the unit. Transmitter has no - Mic sensitivity is too low - Adjust mic sensitivity higher transmission using up/down button 2 12.The loudness of the alarm and beep tone is fixed and independent from adjustment...

Table of Contents