Assembly - Teknetics TreasureTek Elite Owner's Manual

ASSEMBLY

Adjusting the Armrest
The armrest may be moved forward or backwards by removing the single screw
and nut, and then repositioning the 2-piece armrest. Users with shorter arms
may find the armrest more comfortable in the forward position. In order to move
the armrest backwards, the plastic plug must be removed from the aluminum
tube.
Armrest Strap
(optional accessory)
The strap is available for purchase as a separate accessory. Some users prefer
to use the strap when swing the detector vigorously, in order to hold the detector
secure against the arm.
The detector can also be used without the strap, with no compromise to detector
balance and stability under most conditions.
Item # 2021112000
4
OTHER FEATURES
Overload Warning
If a metal object or highly magnetic soil are too close to the searchcoil, the
detector will "overload."
"
mid-tone warning sound.
Overload will not harm the detector, but the detector will not function under
these conditions.
Raise the searchcoil to search at a greater distance, or move to a different location.
Unit of Measure (U/M)
The depth indicator in Pinpoint Mode can display either centimeters (CM) or
inches (IN).
The default unit of measure is centimeters (CM).
To change the unit of measure:
1. Start with the detector turned OFF.
2. Press-and-hold
3. Press
4. Quickly release and then immediately press-and-hold
5. When the desired U/M appears on the screen, release
The detector will now operate with the desired U/M, even after the detector
has been powered down.
To change the U/M again, repeat the procedure.
Memory
To store the current settings (SENS, DISC and VOL):
1. Start with the detector turned ON.
2. Select all desired settings.
3. Press-and-hold
Plastic Plug
When you turn the detector ON for future use, your detector will resume
operation with your programmed settings.
Reset
To return all detector settings to the factory defaults:
1. Start with the detector turned OFF.
2. Press-and-hold
3. Press
4. Release
The 2-digit number displayed is the software revision number.
" will appear on the screen and the detector will make a rapid, repeating
.
.
Continue to hold down .
between CM and IN.
for 8 seconds.
4. When the three menu selections appear at the
bottom of the screen, release
.
.
.
again to toggle
.
.
21