Advertisement

Quick Links

Model No.:
608811
609229 - Can.
TENNANT COMPANY
701 NORTH LILAC DRIVE
MINNEAPOLIS, MN 55422
MAILING ADDRESS:
TENNANT COMPANY
P.O. BOX 1452
MINNEAPOLIS, MN 55440- -1452
NOBLES CUSTOMER SERVICE:
1- - 800- - 365- - 6625
FAX: 1- - 800- - 678- - 4240
TECHNICAL SUPPORT:
1- - 800- - 522- - 7839 EXT. 5356
Troopert 1000
Home
Find... Go To..
Portable Carpet Extractor
Operator and Parts Manual
Rev. 02 (03-04)
608812

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the Trooper 1000 608811 and is the answer not in the manual?

Questions and answers

Summary of Contents for Nobles Trooper 1000 608811

  • Page 1 701 NORTH LILAC DRIVE MINNEAPOLIS, MN 55422 MAILING ADDRESS: TENNANT COMPANY P.O. BOX 1452 MINNEAPOLIS, MN 55440- -1452 NOBLES CUSTOMER SERVICE: 1- - 800- - 365- - 6625 FAX: 1- - 800- - 678- - 4240 608812 TECHNICAL SUPPORT: Rev. 02 (03-04) 1- - 800- - 522- - 7839 EXT.
  • Page 2: Table Of Contents

    E 1999, 2004 Tennant Company Printed in U.S.A. subsidiaries. Nobles is a registered United States trademark of Tennant Company. This machine will provide excellent service. However, Trooper is a United States trademark of Tennant Company. the best results will be obtained at minimum costs if: The machine is operated with reasonable care.
  • Page 3: Safety Precautions

    OPERATION The following information signals potentially dangerous conditions to the operator or SAFETY PRECAUTIONS equipment: FOR SAFETY: This machine is intended for commercial use. It is 1. Do not operate machine: designed exclusively to clean carpet and upholstery in an indoor environment and is not With flammable liquids or near flammable vapors as an explosion or flash fire may constructed for any other use.
  • Page 4: Grounding Instructions

    OPERATION 5. When servicing machine: GROUNDING INSTRUCTIONS Unplug cord from wall outlet. Avoid moving parts. Do not wear loose Machine must be grounded. If it should jackets, shirts, or sleeves. malfunction or breakdown, grounding provides a Use manufacturer supplied or approved path of least resistance for electrical current to replacement parts.
  • Page 5: Machine Components

    OPERATION MACHINE COMPONENTS 1. Machine Lift Handle 10. Accessory Tool Solution Hose Hookup 2. Solution Tank 11. Accessory Tool Vacuum Hose Hookup 3. Recovery Tank 12. 4.6m (15 ft) Vacuum Hose 4. Lockable Casters 13. 4.6m (15 ft) Solution Hose 5.
  • Page 6: Machine Setup

    OPERATION FOR SAFETY: Do not operate machine unless cord is properly grounded. MACHINE SETUP FOR SAFETY: Do not operate machine with the use of additional extension cords. Only use 1. Carefully check carton for signs of damage. manufacturer’s extension cord equipped with Report damages at once to carrier.
  • Page 7: Machine Operation

    OPERATION 8. Attach accessory tool to opposite end of hoses (Figure 5). FLOOR TOOL OPERATION 1. Activate ON/OFF switch to “ON”. 2. Place floor tool so bottom of stainless steel shoes are parallel to floor. Squeeze trigger and apply downward pressure on floor tool head and slowly pull tool backwards using both hands.
  • Page 8: Optional Hand Tool Operation

    OPERATION OPTIONAL HAND TOOL OPERATION DRAINING TANKS NOTE: This machine cleans most synthetic upholstery very well. Extraction in not recommended FOR SAFETY: Before leaving or servicing for most cottons, silks, wools or natural fiber velvets. machine, unplug power cord from wall outlet. Check cleaning instructions sewn in furniture by manufacturer for further instructions.
  • Page 9: Draining Solution Tank

    OPERATION 2. Turn on Vacuum/Pump switch. 3. Vacuum out the leftover solution from the solution tank (Figure 13). 3. Remove solution tank lid and vacuum out leftover solution. 4. Drain recovery tank. MACHINE MAINTENANCE To keep machine in good working condition, simply follow machines daily and monthly maintenance procedures.
  • Page 10: Monthly Maintenance

    OPERATION 6. Remove any clogged debris in the accessory tool 2. Lubricate casters with a water resistant oil. (Figure 16). 3. Inspect machine for water leaks. 4. Inspect machine for loose screws. QUARTERLY MAINTENANCE (Every 250 Hours of Use) Check motor for carbon brush wear, replace brushes if worn to a length of 10mm (0.38 in) or less.
  • Page 11: Storing Machine

    OPERATION STORING MACHINE RECOMMENDED STOCK ITEMS 1. Before storing machine, be certain to flush tanks Refer to Parts List section for recommended stock and drain machine of all water. items. Stock Items are clearly identified with a bullet preceding the parts description. See example below: 2.
  • Page 12: Specifications

    OPERATION SPECIFICATIONS Model Troopert 1000 LENGTH 1054.1 mm (41.5 in) WIDTH 330.2 mm (13 in) HEIGHT 965.2 mm (38 in) MACHINE WEIGHT 36Kg (80lbs) SOLUTION TANK CAPACITY 37.8L (10 gal) RECOVERY TANK CAPACITY 54.8L (14.5 gal) SOLUTION PUMP 120 volt, 100 psi, 1 amp SOLUTION FLOW RATE Floor Tool with 3 tips = 3.8L (1 gal) per minute 127 mm (5 in) Hand Tool with 1 tip = 1L (32 oz) per minute...
  • Page 13: Electrical Diagrams

    ELECTRICAL DIAGRAMS 120V WIRING DIAGRAM BLACK BLACK WHITE MAIN SWITCH GREEN HANDLE CORD POWER 14- -4 CORD BLACK GREEN VACUUM GREEN MOTOR SOLUTION PUMP Troopert 1000 (03- -04) Home Find... Go To..
  • Page 14: Parts List

    PARTS LIST RECOVERY TANK GROUP Trooper t1000 (03- -04) Home Find... Go To..
  • Page 15: Troopert

    ∇ 24 1008639 DASM., CAP, DRAIN HOSE 608807 TANK, RECOVERY GREEN 1008637 DO- -RING, 1.48”ID X 1.76”OD 608186 LABEL, NOBLES LOGO 614157 CLAMP, HOSE 27MM TO 51MM 606394 DECAL, TROOPER 1000 ∇ ASSEMBLY INCLUDED IN ASSEMBLY D RECOMMENDED STOCK ITEMS...
  • Page 16: Chassis Group

    PARTS LIST CHASSIS GROUP Trooper t1000 (03- -04) Home Find... Go To..
  • Page 17 PARTS LIST CHASSIS GROUP PART # DESCRIPTION QTY. PART # DESCRIPTION QTY. 180628 DFILTER, SCREEN 100 MESH 602616 CORD, 16/3 X 47 600451 FITTING, BAG BLADDER PLATE 130181 GRIP, CORD STRAIN-RELIEF 1/2NPT 54333 CLAMP, HOSE WORM 0.31- -0.88D 608814 CHASSIS, GREEN 607305 HOSE, 3/8ID X 5/8OD X 30”...
  • Page 18: Control Console Group

    PARTS LIST CONTROL CONSOLE GROUP Trooper t1000 (03- -04) Home Find... Go To..
  • Page 19 PARTS LIST CONTROL CONSOLE GROUP PART # DESCRIPTION QTY. PART # DESCRIPTION QTY. 608815 ASM., SWITCHBOX BLACK 281001009 DTERMINAL, RING #10 14- -16 ∇ ∇ 1 608515 SWITCHBOX, BLACK W/LABEL 130097 DTERMINAL, FEM .25 16- -14 FI BL 613283 LABEL, WARNING AC EXTR 6X2.25 140823 SCREW, TRS 10- -24 X 0.62 PHL 602669...
  • Page 20: Pump Breakdown

    PARTS LIST PUMP BREAKDOWN PART # DESCRIPTION QTY. PART # DESCRIPTION QTY. 180103 DPUMP, SOLUTION 100PSI 120V 190128 DKIT, UPPER PUMP HOUSING 190129 DKIT, PRESSURE SWITCH 190124 DKIT, CHECK VALVE ONLY 190172 DKIT PRESSURE SWITCH (VITON) 190171 DKIT, VALVE (VITON) 190134 DKIT, DIAPHRAGM ONLY 190131...
  • Page 21: Options

    OPTIONS 127mm (5 in) HAND TOOL GROUP PART # DESCRIPTION QTY. PART # DESCRIPTION QTY. 200505 DASM., HAND TOOL 5” 140609 PIN, ROLL 3/16 ∇ 200431.BK TOOL, HAND 150403 ELBOW, ST 1/4 45° 150913 DFITTING, 1/4F QD FML COUPLER 200992 BODY, SPRAY 1/4F 150606 NIPPLE, HEX 1/4...
  • Page 22: 330Mm (13 In) Low Pressure Wand Group

    OPTIONS 330mm (13 in) LOW PRESSURE WAND GROUP Trooper t1000 (03- -04) Home Find... Go To..
  • Page 23 OPTIONS 330mm (13 in) LOW PRESSURE WAND GROUP PART # DESCRIPTION QTY. PART # DESCRIPTION QTY. 600048 DASM., FLOOR TOOL 330MM (13 IN) ∇ 14 210150 DVALVE, FLOW CONTROL ∇ 200403.BK TOOL, FLOOR BLACK 190603 DKIT, VALVE PIN AND SPRING 120846 DECAL, LOW PRESSURE TOOL 160170...
  • Page 24: 406Mm (16 In) Low Pressure Wand Group

    OPTIONS 406mm (16 in) LOW PRESSURE WAND GROUP Trooper t1000 (03- -04) Home Find... Go To..
  • Page 25 OPTIONS 406mm (16 in) LOW PRESSURE WAND GROUP PART # DESCRIPTION QTY. PART # DESCRIPTION QTY. 200503 DASM., FLOOR TOOL 406MM (16 IN) ∇ 15 210150 DVALVE, FLOW CONTROL ∇ 200411.BK TOOL, FLOOR 190603 DKIT, VALVE PIN AND SPRING 120846 DECAL, LOW PRESSURE TOOL 160170 WAND HOSE ASSEMBLY, 46 IN.
  • Page 26: Upholstery Tool Group

    OPTIONS UPHOLSTERY TOOL GROUP PART # DESCRIPTION QTY. PART # DESCRIPTION QTY. 200540 DASM., TOOL UPHOLSTERY SER 60 200844 DHOSE, VACUUM W/O CUFFS ∇ 200845 COVER, UPHOLSTERY TOOL 200837 DHOSE, SOLUTION 200843 DGASKET, COVER 200848 FITTING, BRS (3 PCS) 190631 DKIT, SERVICE LP (VALVE ASM.) 200842 DFILTER, INLINE COMPLETE...
  • Page 27: Solution And Vacuum Hoses Group

    OPTIONS SOLUTION AND VACUUM HOSES GROUP PART # DESCRIPTION QTY. PART # DESCRIPTION QTY. 160185 HOSE, SOLUTION 4.6M / 15’ 160400 HOSE, VACUUM 4.6M / 15’ ∇ ∇ (STANDARD) (STANDARD) 610792 HOSE, SOLUTION 7.6M / 25’ 160401 HOSE, VACUUM 7.6M / 25’ (OPTIONAL) (OPTIONAL) 160192...

This manual is also suitable for:

Trooper 1000 609229

Table of Contents