Sony DCR-TRV140E Service Manual page 52

DCR-TRV140E
Viewing images using your computer
– USB Streaming (Windows users only)
If you cannot install the USB driver
The USB driver has been registered incorrectly as
your computer was connected to your camcorder
before installing the USB driver. Perform the
following procedure to correctly install the USB
driver.
Step 1 Uninstall the incorrect USB driver
1 Turn on your computer and allow Windows
to load.
2 Connect the USB jack on your camcorder to
the USB connector on your computer using
the supplied USB cable.
To the USB connector/
USB cable (supplied)/
Computer/
3 Connect the AC power adaptor, and set the
POWER switch to CAMERA or PLAYER.
4 Open your computer's "Device Manager."
Windows XP:
Select "Start" t "Control Panel" t "System"
t "Hardware" tab, and click the "Device
Manager" button.
If "System" is not in the control panel, the
"Pick a Category" screen appears. In this case,
click "Switch to Classic View" instead.
Windows 2000 Professional:
Select "My Computer" t "Control Panel" t
"System" t "Hardware" tab, and click the
"Device Manager" button.
Windows 98 SE/Windows Me:
Select "My Computer" t "Control Panel" t
"System," and click the "Device Manager"
tab.
Viewing images using your computer
– USB Streaming (Windows users only)
Installing "PIXELA ImageMixer
Ver.1.0 for Sony"
Install "PIXELA ImageMixer Ver.1.0 for Sony" to
your computer. "PIXELA ImageMixer Ver.1.0
for Sony" is contained on the CD-ROM supplied
with your camcorder. You can view video images
easily on your camcorder, using your computer
with "PIXELA ImageMixer Ver.1.0 for Sony".
For Windows 2000 Professional users
Log in with permission of Power Users or
Administrator.
For Windows XP users
Log in with permission of Administrator.
(1) Turn on your computer and allow Windows
to load.
While using your computer, close all running
applications.
(2) Insert the supplied CD-ROM into the CD-
ROM drive of your computer.
The application software screen appears.
If the application soft ware screen does not
appear, double-click "My Computer" and
then "ImageMixer" (CD-ROM Drive). The
application software screen appears after a
while.
(3) Move the cursor to "PIXELA ImageMixer"
and click.
The language selection dialogue box appears.
(4) Select the language for installation.
(5) Follow the on-screen messages.
Follow the directions on the screen to install
DirectX. DirectX 8.0 will be installed.
1
2
To the (USB) jack/
3
4
t
t
t
t
t t
t
t
127
(1)
(2)
(3)
(4)
(5)
129
Viewing images using your computer
– USB Streaming (Windows users only)
5 Select the devices underlined in the
illustrations below, and delete them.
Windows 98 SE
Windows 2000
Professional
6 Set the POWER switch to OFF (CHG), and
then disconnect the USB cable.
7 Reboot your computer.
Step 2 Install the USB driver
Perform the entire procedure listed in "Installing
the USB driver" on the page 125.
128
Viewing images using your computer
– USB Streaming (Windows users only)
Capturing images with "PIXELA
ImageMixer Ver.1.0 for Sony"
For Windows 2000 Professional users
Log in with permission of Power Users or
Administrator.
For Windows XP users
Log in with permission of Administrator.
Viewing images
Viewing images recorded on a tape
(1) Turn on your computer and allow Windows
to load.
(2) Connect one end of the USB cable to the USB
jack on the camcorder and the other end to the
USB connector on your computer using the
supplied USB cable.
To the USB connector/
Computer/
(3) Connect the AC power adaptor and insert a
cassette to your camcorder.
(4) Set the POWER switch to PLAYER.
(5) Select USB STREAM to ON in
settings (p. 142).
(6) Select "Start" t "Program" t "Pixela" t
"ImageMixer" t "PIXELA ImageMixer
Ver.1.0 for Sony" on Windows.
(7) Click the input mode button in the left side of
Start-up screen.
130
– 52 –
5
Windows Me
Windows XP
6
7
(1)
(2)
To the (USB) jack/
USB cable (supplied)/
(3)
(4)
in the menu
(5)
t
(6)
t t
(7)
t