Table of Contents
Advertisement
5
Wiring
Indirect Water Heater Sensor Setup (Knight Boiler)
Label all wires prior to disconnection when servicing controls. Wiring errors can cause improper and
CAUTION
dangerous operation.
The sensor supplied contains an Auto Reset High Limit (194°F).
NOTICE
Install tank sensor
The tank sensor is a dual sensor which controls the
temperature of the tank from the boiler(see FIG. 5-3). The
tank sensor has a built-in high temperature limit set at
194°F.
1.
Install the sensor inside the tank as depicted
in FIG. 5-3.
2.
Connect the wire leads to the DHW Tank Sensor
(AUX) connection point on the Knight boiler
connection board (see FIG. 5-3).
3.
The Knight boiler will automatically read the sensor
and default the tank temperature setting to 125°F.
4.
Adjust the tank set point program. Reference the
Knight Installation and Operation Manual for a
detailed explanation of the tank set point program.
Figure 5-3 Indirect Water Heater Controlled Using Tank Sensor
18
Connect tank sensor
1.
Turn OFF the power to the unit. Use wire strippers to strip
one inch of insulation from the ends of each wire that
will be spliced.
2.
Splice the two ends of bare wire by twisting them together
with a pair of electrical pliers. Turn the pliers three or
four times to make a sufficient connection.
3.
Attach a wire nut at the point where the two wires have
been twisted together. Twist the wire nut until it fits snugly,
or until it cannot be twisted any more.
4.
Wrap the wire nut and the two wires with electrical tape to
secure the connection. Cover any exposed wiring with
electrical tape.
TANK BULBWELL
DHW TANK SENSOR / AUTO RESET HIGH LIMIT
(PLACE SENSOR IN TANK BULBWELL & SNAP
CLIP OVER BULBWELL)
SOLAR SENSOR
(FIELD SUPPLIED)
INDIRECT TANK
SDT/SET Installation & Operation Manual
DHW TANK
SENSOR
OUTDOOR
KNIGHT LOW VOLTAGE
TERMINAL STRIP
KNIGHT BOILER
Advertisement
Table of Contents
