Installing The Electronics; Balancing The Hull - Carson T78 "Catherine" Instruction Manual

Installing the electronics

After connecting the RC components, the parts can then be placed in the hull.
The best thing to use for this is Velcro ® tape. The diagram below shows an example for installation:
G

Balancing the hull

Check the balance of the water line repeatedly. To do this, place the boat in the water and check whether the hull lies evenly in the water. If the
balance is not yet perfect, you can move the battery again and replace it in a new position. Repeat this process until the boat is perfectly balan-
ced. If necessary, use additional lead weights, etc.
Assembling the add-on parts
Among other thing, your boat is supplied with other add-on parts such as masts, rigging and small items. etc.
Please remove them carefully from the packaging and assemble them using a little adhesive as can be seen in the cover picture
on the packaging/instructions. Alternatively, insert the hooks of the rigging into the eyes installed in the deck/hull.
22 CARSON RC Premium Boat T78 "Catherine" 500106003