Equalization; Purging; Serial Number; Replacement Parts - Ocean Reef NEPTUNE SPACE PREDATOR Owner's Manual

11

EQUALIZATION

The Neptune Space Predator is equipped with a simple patented internal
device to close the nostrils and allow underwater equalization. By loosening
the screw it is possible to move the plate up and down to find the most
comfortable position to equalize. The silicone caps may easily be turned. By
turning the caps you may adjust them to fit a larger or thinner nose
(distance between the nostrils). Two additional plastic inserts are supplied.
By removing the silicone cap it is possible to install the insert in the plate
(cap post) increasing the distance of the cap from the plate and allowing it
to fit closer to the nostril. This is sometimes necessary for flatter noses or
when a hood is used under the mask.
To close the nostrils for equalization, simply press the top part of the mask.
The two equalization silicone caps will move upward and close the nostrils.
The silicone caps when correctly positioned should allow breathing through
the nose and close the nostrils only when pressing the top part of the mask
to equalize

PURGING

The mask can easily be purged in the event that water enters the mask by
pressing the exhaust button on the second stage. The water will flow out of
the lower valve. The diver should be facing straight ahead, with the exhaust
valve being the LOWEST part of the system.

SERIAL NUMBER

The regulator housing is marked with a serial number that identifies the
product for warranty purposes.

REPLACEMENT PARTS

Replacing the strap assembly (M-8 Strap)
To replace the six adjustable strap harness, manually extract the six straps
from their buckles. Then slip the six straps of the new harness through their
relative buckles making sure to keep the buckles in their seats. The arrow
in the center of the harness tab must point upward and be facing
outward.