Method Of Software Upgrading - Sanyo LCD-46XZ10FH Service Manual

4 User menu setup before leaving factory
Enter into page "LOCK" of user menu, select submenu item "Restore Factory Default" to preset
items before leaving factory as below:
a) Clear out all programs information;
b) Clear out information of parental control (VCHIP);
c) Default setup of user analog data;
d) Set Menu Language as English;
e) Set Power on MODE as Off.

Method of software upgrading

Instruction of factory software burning as Table 6
No. Part No.
N111 5272564002
N108 5272404002
NA04 5272402002
NA05 5272402002
NA06 5272402002
N106 5272402002
Note 1: Write-protect setup method
Enter into burning interface of
Setting", set item "Protect" as "All Protect"; be sure to select item "Config" before burning
software, and write-protect must be re-set after burning program ALL-100 startup every time.
Note 2: Burning and upgrading software method with burning tool ISP
Table 6 Instruction of factory software burning
Part type
EN25Q64-104HIP
AT24C04
AT24C02
AT24C02
AT24C02
AT24C02
program
Instruction of Burned
software before
function SMT
FLASH Yes
HDMI KEY Yes
HDMI EDID Yes
HDMI EDID Yes
HDMI EDID
(supporting Yes
the 3rd HDMI)
VGA EDID Yes
ALL-100, select item "Config", press item "config
Burning method
burned with program
ALL11, write-protect setup,
refer to Note 1 in detail
burned with program ALL11
burned with program ALL11
burned with program ALL11
burned with program ALL11
burned with program ALL11