Assemble & Disassemble The Pedestal Base - Sanyo LCD-46XZ10FH Service Manual

Assemble & Disassemble the Pedestal Base (Option)
If the stand is provided, please read these instructions thoroughly before attempting this installation.
Safety Precautions:
1. Please read these instructions thoroughly prior to attempting this installation.
2. Be sure to handle this product very carefully when attempting assembly. If you are unsure of
your capability, or the use of tools necessary to complete this activity, refer to a professional
installer or service personnel. The manufacturer is not responsible for any damages or
injuries that occur due to mishandling or improper assembly/installation.
3. When using a table or bench as an aid to assembly, be sure to put a soft cushion or covering to
prevent accidental scratching or damage to the unit's finish.
4. The speaker is not intended to support the weight of this display. Do not move or handle this
product from the speaker; which can cause damage to the display not covered under the
manufacturer's warranty.
To install the stand:
1. Remove the stand from the box and place it on a table or bench.
You must pay attention to the direction of the stand. The wide portion of the stand should go towards
the front of the TV.
2. Lay your TV flat (screen down) on the edge of a table or bench. Make sure that you put down a soft
cushion or cloth so that your TV is not scratched.
3. Put the stand close to the TV back, align the stand with the TV by moving the stand steadily until the
Stand Locators align with the locating grooves on the stand. And align the screw holes on the TV back
with the holes in the stand, then secure the stand to the TV with provided screws.
To remove the stand from the TV, perform these steps in reverse order.
Note
The appearance of this product in these illustrations may differ from your actual product, and is for
comparative purposes only.
Locators
Stand
Secure with
four screws
Locating grooves
37