Method Of Software Upgrading Instructions - Sanyo LED-22XR10F Service Manual

Method of software upgrading instructions

Factory software burned instructions listed as Table 4
Loc.
Part No.
No.
N103 5272564002
N106 5272404005
N301 5272402003
N311 5272402003
N305 5272402003
Note 1: Method of write-protect setup: enter into burning interface of ALL-100, tick option "Config",
press item "config Setting", set option "Protect" as "All Protect"; make sure that option "Config"
must be ticked before burning software and write-protect must be reset after ALL-100 burning
software is opened every time.
Note 2: Method of burning and upgrading software online by using ISP burning device:
a) For main board upgrade: connect 4-pin cable of ISP burning device to Debug port of main board
(X107); for the unit upgrade, connect both VGA ports of ISP burning device and main board,
enter into factory menu and set item "Other Settings->ISP Mode" as "ON";
b) Using Mstar online burning program(V4.4.2.0 and higher versions), enter into menu "Device",
tick option "WP Pin pull to high during ISP" , ensure that hardware write-protect of Flash is
removed and erasing process is normal, please refer to Fig. 15;
c) Press menu "Connect", a dialog box "Device Type is MX25L64 will pop up, that is, connection
has been successful, please refer to Fig. 16; if connection is failed, press the first menu "Device"
to select SPI Flash type "MX25L64" manually, then press menu "Connect" again;
Table 4 Factory software burned instructions
Part Type Software function
FLASH
IC_EN25Q64-104HIP
HDCP KEY
IC_CAT24C04WI-GT3
HDMI EDID
IC_CAT24C02WI
HDMI EDID
IC_CAT24C02WI
VGA EDID
IC_CAT24C02WI
Fig. 15 Write-protect setup
Burned before
SMT
Use ALL-100 with write-protect, refer
Yes
to Note 1 in detai
Yes
Yes
Yes
Yes
Burning method
Use ALL-100, etc.
Use ALL-100, etc.
Use ALL-100, etc.
Use ALL-100, etc.