Sanyo LCD-46XZ10FH Service Manual page 14

7) A prompt "Pass" will be displayed beside the key "Run" for successful burning as Fig. 6
Fig. 6 A prompt "Pass" beside the key "Run" for successful burning
8) Need not exit ISP burning interface and only repeat the process 3）and 5）to go on burning
software for other sets.
Note 3: On-line burning and upgrading method from USB port
1） Be sure to format a U disk as FAT32;
2） Copy program file to the U disk with the name "Merge.bin";
3） Power on, be sure to switch to ATV or DTV channel and not to display OSD interface; insert the U
disk into a USB port, then USB upgrading process will begin automatically;
4） Upgrading processes:
A、Reading data from the U disk:
A prompt "Searching USB" is displayed and an indicating light of U disk is twinkling;
B、Burning Flash:
A prompt "Updating! Please don't power off!!!" is displayed and an indicating bar is showing
upgrading schedule; the set will be in Standby mode after the burning process completed;
5） Start up the set again, enter into factory menu to verify software version and time parameters;
then execute item "RESET ALL" to complete the whole burning process.
*** Method of burning from USB could not be sure to be suitable for all kinds of U disks, so please try
other U disks if necessary.