Setting Up The Hardware; Installing The Battery; Mounting The Charger - Uniden MHS115 Owner's Manual

Setting up the Hardware

Installing the Battery

Your radio uses the supplied Lithium Ion battery pack. To install the Lithium
Ion battery pack:
1. Remove the belt clip if installed.
2. Use a screwdriver to turn the battery compartment screw counterclockwise
and then lift up and remove the battery cover.
3. Line up the new battery's connector with the jack inside the battery
compartment (the connector only fits one way).
4. Push the connector in firmly. Tug on the battery wires gently to make sure
you have a good connection.
5. Before replacing the battery cover, check the rubber seal located on the
under side of the cover; make sure that the seal is set in the groove and
that there is no foreign matter under the seal.
6. Replace the battery compartment cover. Tighten the screw securely.
If the rubber seal appears warn, nicked, or dried out, you must
replace it. If the seal looks worn or damaged, contact customer
service to order a replacement (see front cover page for
NOTE
contact information).

Mounting the Charger

You can mount the charger on any flat surface.
1. Use the two holes at the base of the charger as a
template to mark the drill holes.
2. Using a 3mm (1/8-inch) drill bit, drill two holes
13mm (1/2 inch) deep.
3. Use the provided screws to attach the charger to
the surface.
UNIDEN MHS115
16
Handheld VHF Marine Transceiver